 | SystemStateOptionsModel Properties |
The SystemStateOptionsModel type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | AlternateVolumeMapping |
Gets or sets the alternate volume used for staging.
|
| AlternateVolumeStaging |
Gets or sets a value indicating whether or not the system volume staging will be done on an alternate volume.
|
| ApplyPorts |
Gets or sets a value indicating whether source engine and management service ports should be copied to the target.
|
| ClearMonitor |
Gets or sets a value indicating whether or not the failover monitor should be removed at cut over.
|
| IsWanFailover |
Gets or sets a value indicating whether or not this job uses WAN failover.
|
| KeepTargetActivationCode |
Gets or sets a value indicating whether or not the target activation code should be kept after failover.
|
| NicMappings |
Gets or sets the network interface mappings.
|
| ServicesToStopOptions |
Gets or sets the services on the target server to stop during protection.
|
| ShouldApplyDiskSignatures |
Gets or sets a value indicating whether or not disk signatures should be applied at cut over.
|
| SourceReservedAddress |
Gets or sets the reserved IP address on the source server.
|
| StagingFolder |
Gets or sets the folder where operating system files will be staged.
|
| TargetReservedAddress |
Gets or sets the reserved IP address on the target server.
|
See Also