Open topic with navigation

Configuring default connection parameters

Several default connection options are available which allow you to disable or enable the creation of default connection parameters. Ideally, you want Application Manager to create the default parameters. However, if you have modified any of the parameters manually and you do not want your modifications overwritten by the defaults, then you may want to disable the creation of the default connection parameters.

1. Make sure you have a valid domain and servers specified, click Configure from the main Application Manager page, and then select the Advanced tab.

   The fields on the Advanced tab will vary depending on the type of application you are protecting. In addition, the fields will vary depending on if you launched Application Manager in standard or advanced mode.

    

2. Create Replication Set indicates if the default replication set generated by Application Manager will be used to establish an application protection connection. If enabled, the default replication set will be generated and used. Disable this option if you have manually updated the default replication set.
3. Create Failover Scripts indicates if the default failover, failback, and restore scripts generated by Application Manager will be used during those processes. If enabled, the default scripts will be used. Disable this option if you have manually updated the scripts.
4. Create Connection indicates if a connection will be established when application protection is enabled. Disable this option if you want to perform testing on your replication set prior to establishing the connection.
5. Create Failover Monitor indicates if failover monitoring will be started when application protection is enabled. Disable this option if you want to perform testing on your scripts prior to establishing monitoring.
6. Click OK to save the settings.