Including and excluding data to be protected

Make sure you have a valid source and target specified, click Configure protection from the main Full-Server Failover Manager page, and then select the Protection tab.
Specify that data you want to include and/or exclude.

Volumes to include—Select the volumes that you want to protect. You must have the same volumes on the source and target. You cannot deselect the boot volume. If you deselect other volumes, you will not be protecting the entire source server.
Directories to exclude—Select the directories that you want to exclude. If you exclude any directories, you will not be protecting the entire source server.
Add—Click Add to specify a directory to exclude. Enter the name of the directory or click Browse to search for the directory path. Specify Recursive if sub-directories of the listed directory should be excluded also. Specify Non-recursive if sub-directories of the listed directory should be included. Click OK to add the directory to the list of Directories to exclude. Repeat this process to add multiple directories.
Edit—Highlight a directory in the list and click Edit to modify the directory definition. After modifying the directory, click OK to save the changes.
Remove—Highlight a directory in the list and click Remove to delete the directory definition. The directory will no longer be excluded.